How to turn a wire hanger into a laptop stand.
By DIY Maven
All you need is a wire coat hanger and a few well-placed bends and you've got yourself an ergonomic laptop stand.
It starts with a small bend in the middle of the hanger's lower bar. Then, you fold each corner 30 to 45 degrees, about three inches up from the corners.
After that, it's just a matter of adjusting the bent corners to fit your laptop.
For more pictures of the entire process, check out this link.
Did you like this article?
DIY Maven's blog (2054 posts)
Featured Writer
Subscribe to this blog
Member since: 11/07/06
About:
Self-proclaimed Maven of DIY, I'm up for anything from gonzo rehab to dressing a room. Check...
DIY Maven
The original post didn't say, but I noticed that too!
skbatson
Good grief! Where did you get that hanger?!? That's not your ordinary household hanger. That sucker is definitely made to last!
Add a Comment!